Actions
Architecture #15333
closed
User story #15330: Add rudder relay commands
Use relay reload command in relayd unit
Status:
Released
Priority:
N/A
Assignee:
Category:
Relay server or API
Target version:
Fix check:
To do
Regression:
Description
Instead of sighup.
systemd doc says:
Note however that reloading a daemon by sending a signal (as with the example line above) is usually not a good choice, because this is an asynchronous operation and hence not suitable to order reloads of multiple services against each other. It is strongly recommended to set ExecReload= to a command that not only triggers a configuration reload of the daemon, but also synchronously waits for it to complete.
It will also allow catching error while reloading config.
Updated by Alexis Mousset over 5 years ago
- Status changed from New to In progress
- Assignee set to Alexis Mousset
Updated by Alexis Mousset over 5 years ago
- Status changed from In progress to Pending technical review
- Assignee changed from Alexis Mousset to Benoît PECCATTE
- Pull Request set to https://github.com/Normation/rudder/pull/2346
Updated by Alexis Mousset over 5 years ago
- Status changed from Pending technical review to Pending release
Applied in changeset rudder|9c64297cf88785d3f41427ea02f7edcc3967125f.
Updated by Vincent MEMBRÉ about 5 years ago
- Status changed from Pending release to Released
This bug has been fixed in Rudder 6.0.0~beta1 which was released today.
Actions